"B" holder

I have gone through so many ways to hold my girls' headbands and I finally came up with one I LOVE! 

Materials Needed:

1. Silhouette Machine

2. Modge Podge

3. 3M Spray Adhesive

4. 1x12x6ft board

5. Rust-Oleum Heirloom White spray paint

6. Small sponge brush

7. Stamin' Up ink pad in 

8.Saw toothed hanger.

9. Exacto knife

10. Scrapbook paper of choice

11. Hooks.

I started with a 1x12x6 

cut (2) 19" pieces for another project {to come this week}

and this is the remaining piece.

I took her outside {it was finally nice weather} and spray painted the edges in Rustoleum Heirloom White

and let dry.

Next, I nailed in a saw tooth hanger to the back. 

Measured to the middle and leveled.

2. I took my piece of scrapbook paper 

sprayed it with 3m adhesive 

smoothed it out on to the wood 

and let dry.

While that was drying I went to my handy dandy Silhouette and cut out a large B.

Used the spray adhesive to glue into place.

After it dried I used Modge Podge to seal the entire board.

I used my Stampin' Up ink pad to distress the edges.

Here is another corner.

Oh yeah, I added a hook to the corner and will be on the hunt for a few more to add across the bottom

and some darling little knobs for higher up for bracelets and necklaces.

And on the wall!

{please pay no attention to the unfinished wall! Trim is going up shortly Which I will post about of couse}